Tescom DS360H User Manual page 30

DS 300H Series
USER MANUAL
A32 SERVICE LOGIN
A34 BYP ROTATE PHASE
A35 INV STOP
A36 INV DC DOWN
A37 AC CURR LIMIT
A38 FUSE FAILURE
A39 PSP FAILURE
A40 INVERTER START
A43 USER LOGIN
A45 SERV.PASSWORD
If any alarm shown on the LCD panel without A00 and R00 message UPS will start automatically if the
conditions are normal. But if you see A00 or R00 code with any alarm together you must CALL SERVICE !
If the message is warning UPS continues to run there is no problem.
To support technical service status cods are used, each status code tells different event to us.
30
3/3 100-160 kVA
Warning Service login active
Warning By-pass phase sequency incorrect
Warning Inverter module interrupted
Warning DC BUS voltage is less then 120 volts DC
Warning Inverter output current limited
Warning Any fuse in UPS is blowned
Alarm Inverter control board power supply out of tolerant
Warning Inverter is in soft start stage wait for finish
Warning User logged in to UPS
Fault For UPS startup service password required
UPS CONTROLLED UPS
28
www.tescom-ups.gr