Start-Up And Use - Lagrange 50904 Series Manual

START-UP AND USE

ST USE
1
Fully extend the cable and examine it carefully before using it.
*
Fill the appliance with water to the maximum level («MAX»).
*
Switch on the appliance as described in the section «Use of the
*
unit». Let the water boil.
Pour out the water after it boiled.
*
Repeat this procedure.
*
Your appliance is now ready to use.
*
USE OF THE UNIT
Open the lid by using the handle.
*
Fill the kettle with water to the desired level while observing
*
the specified levels ( . L MIN to
0 5
water through the spout. This improves filter maintenance.
Caution: do not use without water!
Close the lid and make sure it is firmly closed.
*
Place the appliance on its base.
*
Power up the appliance by connecting the power plug.
*
Press the on/off button. The kettle will heat the water to
*
Press the setting button to select the required temperature. There are
*
temperatures to choose from:
4
Press the on/off button. The kettle will heat the water to the
*
selected temperature.
The kettle will stop automatically on reaching the required
*
temperature. The on/off button light will go out and the kettle
will beep twice.
. L MAX). You can fill with
1 7
°C.
100
°C, °C, °C and °C.
50 70 80 90
Press the temperature setting buttons then hold down the on/
*
off button for seconds until you hear a beep to activate the
3
keep warm function. The kettle will boil the water to the selected
temperature and keep it warm for
selected temperature will flash the whole time that it is kept warm.
Use can be interrupted at any time by pressing the on/off button.
*
When you put the kettle back on its base it will beep twice.
*
Unplug the power supply after use.
*
Suggestion: you can shorten the length of the cord using the
storage compartment provided under the base.
Boil-dry protection device
If the MIN water level is not observed, the boil-dry protection
device, which is the kettle's safety mechanism, will be activated,
turning the kettle off. In this case, disconnect the kettle and wait
for minutes before using it again.
15
36
30 minutes. The indicator for the