Lagrange 50904 Series Manual page 33

To use the kettle again, disconnect it and let it cool
for 15 minutes, then refill it and switch it on again.
The water level must be between the MIN and
*
MAX water level gauge markings. Overfilling the
kettle may cause the water to spill when boiling
and cause burns.
Make sure to close the lid tightly before use to
*
prevent scalding by the emitted steam.
Be careful never to open the kettle lid when the
*
water is still hot. The steam emission may cause
burns!
While the kettle is on, do not touch any surfaces
*
other than the side handle. They get very hot and
may cause burns.
Do not move the appliance while in use.
*
Caution: the appliance remains hot after use.
*
Always allow the appliance to cool before storing
or cleaning it.
Keep the appliance or the cord away from any
*
sources of heat, hot objects or open flame.
Disconnect from the outlet during cleaning.
*
To remove the anti-scale filter, lift the kettle off it
*
base and allow it to cool. Never remove the filter
when the appliance contains hot water.
Do not pull on the power cord or on the appliance
*
itself to disconnect it.
Never place your appliance on a hot surface.
*
To avoid hazards, do not use the appliance after
*
dropping it and if it shows visible signs of damage.
If your appliance has been damaged, stop
*
using it and contact the Customer Service of
If your appliance has been damaged, do not
*
attempt to repair it yourself. Any unauthorised
modifications or repairs of the appliance will void
the warranty.
To ensure your safety, use only
*
accessories and spare parts that are suitable for
your appliance.
This appliance is exclusively intended for
*
domestic use. Commercial or any other use
is prohibited. The manufacturer declines any
liability should this principle not be observed.
33
E N G
.