Table of Contents
Advertisement
Belt Guards
Figure 7-7
6.
Then route the belt around the two deck idler pulleys as
shown in Fig. 7-8.
7.
Retighten the belt keeper rod loosened earlier.
8.
Remount the belt guards removed earlier.
9.
Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
10.
Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-9.
11.
While holding the belt and pulley together, rotate the
pulley to the left (See Fig. 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
Hex Screws
Belt Keeper Rod
Deck Idler Pulley
Front Spindle
Pulley
Deck Idler
Pulleys
outer Spindle
Pulleys
Figure 7-8
Figure 7-9
S
ection
PTo Belt
Rotate
Pulley
7 — S
27
ervice
Advertisement
Table of Contents
