Proper Location For Installing Your Heater; Operation; Reset Button - Bosch Therm C 1210 ES Installation And Operating Instructions Manual

WARNING:
▶ In applications where inlet water temperature can exceed
140°F (60ºC), a thermostatic or mixing valve must be
installed before the appliance to prevent water exceeding
140°F (60°C) from entering the appliance.
Fig. 56
6.5 Use of optional remote control accessory
(part no. TSTAT2)
Fig. 57 Remote control
The wireless remote control accessory (Fig. 81, component
13) and the temperature selector buttons on the front of the
C 1210ES/ESC – 6 720 644 887 (2022/04)
water heater operate identically. Contact your distributor to
order the remote control accessory. Modification of the water
heaters interior control unit (Fig. 81, component 16) is
required when installing the remote control with this heater.
NOTE: up to 6 remote controls can be programmed for one
single water heater, each with a range distance of 98 ft (30 m).
6.6

Operation

▶ When a hot water tap is opened, main burner ignites and
LCD displays indication
Fig. 58
▶ LCD flashes until selected temperature is reached.
▶ Power bar indicates power percentage in use.
6.7

Reset button

If the LCD shows the error symbol
or unplug the heater. Follow instructions below to reset error
first.
Record the error code on LCD and consult "Problem solving"
chapter 9.1, page 60.
Fig. 59
After following instructions indicated in "Troubleshooting"
section,
▶ press reset button firmly in order to return heater to normal
operation.
Operation instructions
.
do not shut off power
49