Advertisement
4.5. Reversing the Door
The door opening can be reversed from "right hand hinged" to "left hand hinged" if
required. If your appliance is supplied "left hand hinged" simply reverse the
following procedure.
Warning!
When reversing the door, the appliance must not be connected to the mains.
Remove the plug from the mains beforehand.
•
Remove the top hinge cover
•
Lean the appliance back and prop it up securely at the front
•
Remove the top door hinge screws and remove the hinge bracket
•
Remove the door from the lower hinge
•
Now remove the lower hinge bracket and unscrew/remove the central hinge
pin. Turn the hinge over and refit the hinge pin as shown below
•
Secure the lower door hinge into place on the opposite side of the appliance
•
Now ensure both levelling feet are in place and secure
•
Now position the door onto the lower hinge bracket
•
Now refit the upper hinge bracket on the opposite side of the appliance
•
Do not fully tighten the screws until you have tested that the door closes
correctly and that the door seal is tight
•
Now secure all the screws
•
Refit the top hinge cover.
N.B. Service calls relating to door problems and/or cooling issues will be
chargeable if the fault is found to be due to an incorrect door
reversal procedure carried out by the consumer!
14
Advertisement
