Table of Contents
Advertisement
ENGLISH
Advanced Shooting
Snap Shot (VP-W87/W87D only)
With the SNAP SHOT feature, your camcorder can function like a normal film camera, allowing you to take single still
pictures.
-
The SNAP SHOT function only operates in the CAMERA mode.
1. Set the power switch to CAMERA mode.
2. Press the SNAP SHOT button when you have the picture
you wish to capture.
At this time, be careful not to shake your camcorder
because the image will be indistinctly recorded.
3. Once the SNAP SHOT button has been pressed, your camcorder will
automatically return to STANDBY mode after approximately 6 seconds.
You can check the remaining available SNAP SHOT space by
looking at the time displayed on the screen.
To stop SNAP SHOT shooting, press the SNAP SHOT button
again.
Notes:
If the camcorder is knocked or shaken while taking a SNAP SHOT, the image may be blurred.
The SNAP SHOT is activated in recording.
When the SNAP SHOT button is pressed in CAMERA mode with no tape installed, a still image will be
displayed in the viewfinder.
46
CAMERA
Advertisement
Table of Contents
