Advertisement
This heater must be properly placed before it is used.
DO NOT tamper with or change the operating of this heater.
All service should be preformed by a authorized service
representative.
1.
After the electric heater has been completely placed, the
thermostats should be turned to LOW or NO HEAT
position.
2. Plug unit into grounded outlet. Do not use extension
cords.
3.
Turn thermostats to highest position and wait 3 to 5
1.
Turn power OFF to unit before
replacing filters.
2.
Loosen 4 thumb screws per air filter.
3.
Slide old filter out from support
channels.
4.
Slide new air filter into support
channels.
5.
Retighten thumb screws to secure air
Before cleaning heater,
!
elements must be cool.
1.
Before removing front louver housing, turn the electri-
cal power OFF by unplugging it. If not, electricity may
still be flowing to the heater. If you are uncomfortable
working with electrical appliances consult a qualified
electrician. Once power is off completely, proceed to
the next step.
103889
minutes. Check to see that all heaters are operating.
Should any not be operating, disconnect power and
check wiring.
4. Allow entire system to operate steadily for 1/2 hour.
This should remove oily residue from manufacturing.
(Some smoking may occur).
Selecting desired temperature on the thermostat:
To adjust the temperature to your requirements, turn the
dial on the thermostat clockwise all the way to turn heater
on. When the room reaches the desired temperature, turn
the thermostat knob counter clockwise until you hear the
2.
Remove screws located on the sides of the front louver
heating
housing. Wipe housing with soft cloth or brush.
3.
Using a hair dryer or vacuum on blow cycle, blow debris
back through the element. Do not touch elements. Vac-
uum lose debris without touching the elements.
4.
Replace front louver housing and secure with screws.
5.
Wipe the fan and motor with a soft cloth or brush.
Rev 12.16.19
5
Advertisement
