Advertisement
4. Prepare for Front and Rear Handles installation by
first removing the Top Cover (Door) to gain access to
mounting the handles.
Insert Front Handle (#13) into metal channels on
sides of the unit, according to the assembly drawing.
Secure with bolts (#31), washers (#32) and nuts (#17)
6. Install Rear Handle (#6) following this same pro-
7. Reattached Top Cover, making sure screws are properly
tightened.
8. Install proper plug configuration (Plug: Hubbell
#HBL4100P9W) at the end of the power cord. (See Page
2 for details).
Place heater at least 6" (15cm) away from vertical sur-
faces and keep the intake clear of obstructions. Keep all
combustible
103889
materials, such as furniture, papers, clothes, drapes,
and curtains at least 3 feet (0.9 m) from the front of
the heater and keep them away from the sides and
rear.
Route power cord away from traffic areas to avoid
tripping.
NEVER rout power cord under carpets, rugs, drops
7.
furniture or other equipment.
8. Plug power
# HBL4100R9W) (See Page 2 for details)
use an extension cord.
9. Wiring diagram located in wiring housing.
10. WARNING: This heater is for floor use ONLY and
should not be tipped on side, placed upside down,
mounted on or inserted into a wall. A tip-over au-
to disconnect switch will activate when tipped
more then 30°.
11. DO NOT use heater in areas where gasoline, paint,
or other flammable liquids are used.
12. DO NOT use heater outdoors or in wet or moist
indoor areas such as bath or laundry rooms.
13. Store unplugged and in a dry indoor location.
This heater is for use on 208 volts. The type outlet
is a 208 volt grounding outlet. When properly in-
stalled, it provides a ground connection through
Rev 12.16.19
cord into a grounded wall outlet (Hubbell
only. DO NOT
4
Advertisement
