Honda CLARITY Plug-In Hybrid 2020 Owner's Manual page 463

Illumination Lamp
Charge Lid
Plug
POWER Indicator
Charge Indicator
Charging Connector
5. Open the vehicle's charge lid.
6. Insert the plug into a 120 volt wall outlet.
u Insert the plug completely until it stops.
7. Check that the POWER indicator on the
control box comes on.
8. Remove the cover from the charging
connector. Align and insert the charging
connector into the vehicle's inlet until you
hear a click.
u The charge indicator stops blinking, and
stays on when charging starts.
uuCharginguCharge the High Voltage battery using a Level 1 or 2 charger
1Charging
NOTICE
Do not charge the vehicle with a vehicle cover on. It
can cause a malfunction and damage the vehicle or
charging components.
The 120 volt charger requires a properly grounded
and dedicated 15 amp or greater circuit. For more
information consult an authorized Honda Clarity
Plug-In Hybrid dealer.
We recommend that a GFCI (ground-fault circuit
interrupter) protected outlet be used to charge the
vehicle. Follow the GFCI maker's installation
instructions, or consult an electrician if you are not
sure about installation requirements.
Inspect the charging cable plug and charging
connector, as well as the vehicle's charge inlet,
before use. If the plug or connector are dirty or
otherwise contaminated, carefully clean them with a
dry clean cloth before use. Do not wipe the metal
part of the inlet and the charging connector. Also, if
you are unable to clean the plug or connector, if the
inlet is dirty, or if any are damaged or corroded, take
the charging cable and vehicle to an authorized
Honda Clarity Plug-In Hybrid dealer for inspection
and possible repair.
Continued 461