Table of Contents
Advertisement
Quick Links
®
The HYBRIDFLUSH sends out an infrared beam that senses a user on a urinal or toilet. Once the user walks away from the
fixture the unit triggers the fixture to flush automatically. The unit's unique design includes two manual flush buttons (one electronic
and one mechanical) to allow for a courtesy manual flush option and for continuous manual activation when batteries are drained.
<
HYBRIDFLUSH Components
Collar
Gasket
=
Installation
Pre-Installation Note:
Although not necessary, it is recommended to shut off
water supply at stop.
c
Using the supplied collar wrench, loosen handle
from flush valve.
d
Remove handle from flush valve.
Note: A small amount of water may drip out while
removing handle so be prepared to collect
it with a rag or towel.
e
Place collar gasket into collar nut and attach the
®
HYBRIDFLUSH unit where the handle was removed.
f
Tighten collar nut using the supplied collar wrench.
Note: Save removed handle in case you need to reuse
for service of HYBRIDFLUSH unit.
HSM-801
Series
®
Four (4) "C" Cell
Alkaline Batteries
(Factory Installed)
®
HYBRIDFLUSH Unit
c
e
®
Page 1
HYBRIDFLUSH
SIDEMOUNT for Urinals and Toilets
Installation and Operation Manual
Senses User
User Approaches
Battery
Compartment
Wrench
Collar
Wrench
Collar
Collar Nut
Gasket
®
Flushes When
User Leaves
Collar
Wrench
d
f
PUSH
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AMTC HYBRIDFLUSH HSM-801 Series
Summary of Contents for AMTC HYBRIDFLUSH HSM-801 Series
- Page 1 ® HYBRIDFLUSH HSM-801 SIDEMOUNT for Urinals and Toilets Series Installation and Operation Manual Senses User Flushes When User Approaches User Leaves ® The HYBRIDFLUSH sends out an infrared beam that senses a user on a urinal or toilet. Once the user walks away from the fixture the unit triggers the fixture to flush automatically.
- Page 2 > Activation Battery Tray Note: Four (4) “C” Cell batteries are factory installed ® inside the HYBRIDFLUSH unit. The unit is shipped from factory with battery tray unplugged and must be plugged in to activate. ® To activate the HYBRIDFLUSH unit: Battery Connector A - Using supplied battery compartment wrench, remove...
- Page 3 Battery Replacement Battery Tray A - Using supplied battery compartment wrench, remove side cover. B - Slide out battery tray and disconnect battery connector. C - Remove old batteries from tray and load new batteries (note position of batteries in tray). Battery Connector D - Reinstall battery tray into unit and reconnect battery connector.
- Page 4 Parts List Ref. # Part # Description HSM-AA HYBRIDFLUSH Sidemount Actuator Assembly HSM-BT HYBRIDFLUSH Sidemount Battery Tray HSM-SCA HYBRIDFLUSH Sidemount Side Cover Assembly HSM-SCS HYBRIDFLUSH Sidemount Side Cover Screw Page 4...
- Page 5 FOR A PERIOD OF FIVE (5) YEARS FROM DATE OF PURCHASE, WHEN PROPERLY INSTALLED AND UNDER NORMAL USE AND SERVICE. THESE PROVISIONS DO NOT INCLUDE THE BATTERIES SHIPPED WITH THE PRODUCTS. A DEFECTIVE PRODUCT MAY BE RETURNED TO AMTC OR ITS AUTHORIZED REPRESENTATIVES WITHIN FIVE (5) YEARS FROM DATE OF PURCHASE WITH THE PROPER INVOICE OF PURCHASE.
Need help?
Do you have a question about the HYBRIDFLUSH HSM-801 Series and is the answer not in the manual?
Questions and answers