Table of Contents
Advertisement
To remove the memory module
1 Follow step 1 to 2 of the "To install the memory module" section to shut down your Synology NAS,
disconnect the cables and remove the cover.
2 Push the levers on both sides of the memory module outward. The memory module will be released from its
slot.
3 Hold the memory module by its edges and remove it from the slot.
4 Replace the cover and tighten the two screws that removed.
5 Reconnect the cables that removed, then press the power button to turn on your Synology NAS.
17 Chapter 2: Hardware Setup
Advertisement
Table of Contents
