Advertisement
7. MAINTENANCE
IMPORTANT: Only fully qualified personnel should attempt maintenance or repair. Check the condition of the markings. These must be
maintained in their original condition.
7.1.
MONTHLY MAINTENANCE
Lubrication is critical to jacks. Any restriction due to dirt or rust can cause either slow or extremely rapid jack movement, causing damage
to the internal components.
7.1.1.
Lubricate the ram, all of the pivot points, the linkages and the saddle and pump mechanism with light oil.
7.1.2.
Grease points: front wheels and handle pivot see fig.6.
7.1.3.
Keep all jack surfaces and warning labels clean.
7.1.4.
Check and maintain the ram oil level (Section 7.3).
7.2.
THREE MONTHLY MAINTENANCE
7.2.1.
At three monthly intervals, check the ram for any signs of rust or corrosion. Clean the ram as required and wipe with an oiled cloth.
7.3.
CHECKING THE OIL LEVEL
7.3.1.
Fully retract the ram by turning the release valve counter-clockwise.
7.3.2.
With the jack in the level position, remove the oil filler plug (fig.5).
7.3.3.
The oil should be level with the bottom of the oil filler hole. If it is not, top up with clean hydraulic jack oil.
7.3.4.
Replace the oil filler plug and check the jack operation.
7.3.5.
Purge air from the hydraulic unit as required. Refer to Section 5.
NOTE: Always store the jack in the fully lowered position. This will protect critical areas from excessive corrosion.
Owing to their size and weight, hydraulic products should ideally be repaired by local service agents. We have service / repair agents
in most parts of the UK. Before returning your product please call our technical helpline on 01284 757505 for advice
and troubleshooting guidance. If the jack is under guarantee please contact your stockist.
fig.5
2tonne
configuration
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.6
3tonne
configuration
Original Language Version
sales@sealey.co.uk
3tonne
SUPER HIGH LIFT
configuration
www.sealey.co.uk
3200LEHL Issue 2 (2) 28/04/23
REGISTER YOUR
PURCHASE HERE
Advertisement
