Advertisement
Installation
Installation
1. Clean all material from the seal grooves. Lubricate
ram plate grooves before assembly.
2. Assemble two bands (3) together. Align one end of
band about 9 in. from jack screw and tape attached
band. Install screw jack in slot.
1
3. Insert jack screw end of band (3) into hose (1 or 2)
and push completely through hose.
2
1
2, 3
3 (x2)
NOTE: To prevent material from potentially leaking past
both hoses, ensure hose (1,2) seams are 90°-180°
apart, and not on top of each other.
4. Lubricate outside of hoses (1,2) and place on upper
or lower groove on plate. Adjust hose and band so
that the angled ends of hose press against each
other. Tighten two ends of banding (3) together with
jack screw.
5. Work hose to completely close gap at the ends.
2
1
3
334048E
Advertisement
