Sound Adjustment; Setting The Surround Mode; Adjust The Woofer Level Settings - LG LAS475B Owner's Manual

18 Operating
,
Note
y When using Bluetooth technology, you have
to make a connection between the unit and
the Bluetooth device as close as possible and
keep the distance.
However it may not work well in the case
below :
- There is a obstacle between the unit and
the bluetooth device.
- There is a device using same frequency
with Bluetooth technology such as a
medical equipment, a microwave or a
wireless LAN device.
y You should connect your Bluetooth device to
this unit again when you restart it.
3
y The sound may be interrupted when the
connection has interference from other
electronic waves.
y You may not control the Bluetooth device
with this unit.
y Pairing is limited to one Bluetooth device per
unit and multi-pairing is not supported.
y Depending on the type of the device, you may
not be able to use the Bluetooth function.
y You can enjoy Bluetooth function using
Smart phone, MP3 player, Notebook, etc..
y The more distance between the unit and the
Bluetooth device, the lower the sound quality
becomes.
y Bluetooth connection will be disconnected
when the unit is turned off or the bluetooth
device gets far from the unit.
y When Bluetooth connection is disconnected,
connect the bluetooth device to the unit
again.
y When this unit is not connected with
Bluetooth device, Bluetooth LED will blink.

Sound adjustment

Setting the surround mode

This system has a number of pre-set surround sound
fields. You can select a desired sound mode by using
each sound mode button.
Button
STANDARD You can enjoy optimized sound.
You can enjoy more immersive
CINEMA
and cinematic surround sound.
This program make voice sound
VOICE clear, improving the quality of
voice sound.
,
Note
y In some of the sound effect modes, some
speakers may have no sound or low sound.
It depends on the mode of sound and the
source of the audio, it is not a defect.
y You may need to reset the sound effect
mode, after switching the input, sometimes
even after the sound file changed.

Adjust the woofer level settings

You can adjust the sound level of woofer by pressing
WOOFER LEVEL o/p button.
,
Note
When the subwoofer level reaches maximum
or minimum, standby LED (Red) on the main
unit turns on for 2 seconds.
Description