Table of Contents
Advertisement
Using the Remote
Using Automatic Code Search
The following instructions can be used to program the remote to control
each of the devices connected to your TV. If you want to exit the
automatic code search without programming any of your devices, press
CLEAR until the LED turns off.
1.
Turn on the device you want to control (VCR, satellite receiver, etc.)
2.
Press and hold the device button you want to program (VCR, AUX,
DIRECTV, etc.). While holding the device button, press and hold
ON•OFF until the red light on the remote turns on, then release
both buttons.
3.
Press and release PLAY, then wait 5 seconds or until the LED stops
flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are 20 total sets of codes. If
the device does not turn off after pressing PLAY 20 times, then the
remote cannot control that particular device.
If the device you want to control does turn off:
1.
Press and release REVERSE, then wait 2 seconds. Repeat this step
until the device turns back on.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
Using Direct Entry
1.
Turn on the component to be programmed.
2.
Look up the brand and code number(s) for the component on the
code list on the last page of this section, Using the Remote.
3.
Press and hold the button on the remote you want to program.
4.
Enter the code from the code list.
5.
Release the button, and then press ON•OFF to see if the component
responds to the remote commands. If it doesn't, try pressing the
component button and then ON•OFF again.
6.
If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
commands.
This remote may not operate all models
of the brands that are shown. Use the
codes shown in this manual, or on the
sheet packed with your remote.
19
Advertisement
Table of Contents
