Selecting A Power Level For; The Heater - Beko HIC 95600 T1 User Manual

Selecting a power level for a heater
To switch on a heater it is necessary to
actuate every cooking zone by means of two
operations:
Select a heater
Select the desired cookset
Selecting a heater
A heater is selected by touching the heater
[HEATER_n_KEY] key for 160 ms, a beep
sounds and the heater display shows the
power level.
The heaters that are not selected are shown
with a dot point.
The [HEATER_n_KEY] key will be locked
to select a heater:
If the cooktop is off (all the heater
displays off), or
if the key lock is activated , or
if there is any heater or appliance error.
The heater selection will finish:
10 second after the last touch over the
[SLIDER] key
if another heater is selected
or if the [HEATER_n_KEY] key is
touched for 160 ms.
When the heater selection is finished after
10 seconds, a beep sounds and all the
heater displays show the power levels again.
Page 14
Heater selection