Power-Button Assembly; Removing The Power-Button Assembly - Dell Alienware m15 R4 Service Manual

Steps
1. Place the power-adapter port into the slot on the palm-rest assembly.
2. Place the power-adapter port bracket on the power-adapter port.
3. Align the screw holes on the power-adapter port bracket to the screw holes on the palm-rest assembly.
4. Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
Next steps
1. Follow the procedure from step 3 to step 24 in
2. Install the right I/O-board.
3. Install the rear I/O-cover.
4. Install the M.2 2230 solid-state
5. Install the M.2 2280 solid-state
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Power-button assembly

Removing the power-button assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the M.2 2230 solid-state
5. Remove the M.2 2280 solid-state
6. Remove the rear I/O-cover.
7. Remove the right I/O-board.
8. Follow the procedure from step 1 to step 19 in
Installing the system
drive, if applicable.
drive, if applicable.
After working inside your
Before working inside your
drive, if applicable.
drive, if applicable.
Removing the system
board.
computer.
computer.
board.
59