General Description - Fieldmann FDSP 200651-E Manual

EN
14

General description

3. GENERAL DESCRIPTION
DESCRIPTION AND LOCATION OF MACHINE PARTS
1.
Nozzle
Air Cap Ring
2.
Gun Body
3.
Trigger
4.
Fluid Adjusting Screw
5.
Air Tube
6.
Valve Cap
7.
Paint Container
8.
Hose
9.
10. Carrying Belt
11. On/Off switch
12. Plug
13. Viscosity cup
KINDS OF MATERIALS
Only use materials recommended for spray
guns. Preparing the coating material.
You can use the spray gun to spray undiluted or slightly diluted paint, lacquer and
varnish.
If the paint needs to be diluted, start by diluting it by 10%. Fill a container with one
liter of the paint you wish to use. Keep in mind that the viscosity measuring cup
holds up to one deciliter. Cover the opening and fill the cup with the required
amount of thinner. Add the thinner to the paint and stir well. Measure the viscosity
following the recommendations given below. If the paint needs to be diluted
further, dilute it by another 5%(half the measuring cup) and measure the viscosity.
If the paint still has not reached the recommended viscosity, repeat the previous
step until the correct viscosity is reached.
This spray gun can be used with products with a viscosity index of 25 to 50 seconds.
Submerge the viscosity measuring cup in the material to fill it. Time how long it
takes for all the material to flow out of the cup (Figure 2).
Use the following recommendations as a guide, but also consult the
manufacturer's instructions on the material you wish to use to find out if the
material needs to be diluted. Recommendations:
FDSP 200651-E