Changing Data Interface Network Settings; Resetting To Factory Defaults; Restarting The Fortigate-7030E - Fortinet FortiGate-7030E System Manual

Getting started with FortiGate-7000
set password <new-password>
end

Changing data interface network settings

To change the IP address of any FortiGate-7030E data interface:
From the GUI access the Global GUI and go to
l
and other settings.
From the CLI:
l
config system interface
edit <interface-name>
set ip <ip-address> <netmask>
end

Resetting to factory defaults

At any time during the configuration process, if you run into problems, you can reset the FortiGate-7030E to factory
defaults and start over. From the primary FIM CLI enter:
config global
execute factoryreset

Restarting the FortiGate-7030E

To restart all of the modules in a FortiGate-7030E, connect to the primary FIM CLI and enter the
command. When you enter this command from the primary FIM, all of the modules restart.
To restart individual FIMs or FPMs, log in to the CLI of the module to restart and run the
FortiGate-7030E 6.2.3 System Guide
Network > Interfaces . Edit any interface to change its IP address
Fortinet Technologies Inc.
execute reboot
execute reboot command.
27