Table of Contents
Advertisement
4. Dispenser Solenoid Valve (Dispenser Models Only)
1) Disassembling Procedure (Features are model dependent)
No
1
Disassemble the Cover dispenser Box As
2
Separate Front PCB connector.
(Features are model dependent.)
3
Unscrew to remove Box Dispenser Ice Shut.
2) How to check Dispenser Solenoid Valve
Parts
Dispenser Solenoid Valve
Flap Heater Assembly
All manuals and user guides at all-guides.com
Procedure
How to Check
HOW TO CHECK EACH PART
No
4
Disconnect 2 terminals and 2P Wire.
5
Unscrew and remove Solenoid Valve.
6
Unscrew and remove Cover Ice Flap.
Check the resistance of
both terminals.
(Defective): Change the part.
Check the resistance of
2 terminals with a Tester.
(Defective): Change the part.
30
Procedure
Remark
( Good ): 215 Ohm (+-10%)
(193 ~ 236 Ohm)
( Good ): 96 Ohm (+-8%)
(88 ~ 104 Ohm)
Advertisement
Table of Contents
