EAW QX Series Application Manual page 89

Passive Point Source
5. Installation of an MKC Series Loudspeaker
to the Metal Pan & Tilt Bracket.
a. Choosing an MKC Series
Loudspeaker configuration
i. Note if loudspeaker will need to pan
or tilt, or perform a combination of
both options.
ii. Consider orientation of loudspeaker
(horizontal or vertical) before
securing speaker bracket.
iii. To connect bracket to the
speaker, remove hardware from
rear of MKC Series, place
speaker bracket over mounting
pattern, and secure with previously
removed hardware.
b. Connecting Speaker Bracket to Wall Bracket
i. Line up the two exposed speaker bracket
holes with opening in pivot block
ii. Slide Button Head Hex Drive Screw
connect brackets together
iii. Tighten with lock and oversized
washers using 6mm allen wrench.
Application Guide
Each mounting hole will correspond to
mounting hole on an MKC Series product
Connecting the Pan & Tilt Wall and
c. Configuring Pan & Tilt angles
NOTE: Not all angles will be achievable due to
the physical restraints of loudspeakers used with
bracket.
NOTE: Depending on orientation of the wall
bracket pan and tilt hardware configuration will
vary
Tel 800 992 5013 / +1 508 234 6158
Speaker Brackets
|
www.eaw.com
89