Mazda CX-5 2021 Owner's Manual page 322

When Driving
i-ACTIVSENSE
When the steering operation assist has
been changed to inoperable (OFF), only
the lane departure warning is operational.
System operation
Make sure that the LAS & LDWS OFF
indicator light in the instrument cluster is
turned off. When the LAS & LDWS OFF
indicator light turns on, press the switch
and make sure that the indicator light turns
off.
Drive the vehicle in the center of the
driving lane while the LAS & LDWS OFF
indicator light in the instrument cluster is
turned off.
The system becomes operational when all
of the following conditions are met.
The system detects white (yellow) lane

lines on both the right and left sides or
on either side.
The vehicle speed is about 60 km/h (37

mph) or faster.
The vehicle is driven on a straight road

or road with gentle curves.
The engine is running.

The LAS & LDWS goes on stand-by
status in the following cases:
The system cannot detect white (yellow)

lane lines.
The vehicle speed is less than about 60

km/h (37 mph).
The vehicle is making a sharp curve.

4-166
The vehicle is making a curve at an

inappropriate speed.
NOTE
The LAS & LDWS remains on stand-by

until it detects white (yellow) lines on
both the left and right sides, or on either
side.
When the system detects a white

(yellow) lane line on one side only, the
system will not activate warnings for the
lane line on the side that is not being
detected.
The distance and warning sensitivity

(likelihood of a warning) which the
system uses to determine the possibility
of a lane departure can be changed.
(Mazda Connect (Type A) only)
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Vehicle lane line display
When the LAS & LDWS becomes
operational while on standby, the vehicle
lane lines are displayed in the
multi-information display. The system
changes to operational status display when
the system detects a white (yellow) line on
either the left or right.
(Stand-by status)