Setup and Connections
Sample Connections
The following are sample connection scenarios you may encounter when
connecting components to your TV.
Cables
You will use the following type of cable to make
your connection:
Coaxial Cables: Carries the signal from the
antenna or cable directly to the television or
through a cable box, as needed by your cable
system.
TV and VCR
CABLE, CABLE BOX, OR ANTENNA
VCR 1
TV
VCR
CONTROL
IN FROM ANT
CH3
CH4
OUT TO TV
CABLE/
ANTENNA
Cautions:
Position Cables to Avoid Audio Hum
or Interference
• Insert all cables firmly into jacks.
• Try not to coil any twin-lead cables and
keep them away from any audio/video
cables.
Protect Your Components From
Overheating
• Do not block ventilation holes in any of
the components. Arrange the
components so that air can circulate
freely.
• Do not stack components.
• Allow adequate ventilation when
placing your components in a stand.
• Place an amplifier on the top shelf of
the stand so heated air rising from it
will not flow around other
components.
How to View Your VCR
To watch the VCR in this connection, turn on
both the TV and the VCR, then tune the TV to
the channel you specify on the back of the VCR
(in this case, channel 3).
7