Advertisement
GEO 400, 600, 800 & ROCKER PANEL
WIRING INSTRUCTIONS
Step 1: In order to power the unit, extend
the red, 12V(+) wire to the 12V(+) post of
the vehicle's battery. Extend the black
12V(-) wire to the ground post of the
vehicle's battery.
Step 2: To turn the lightstick on, connect the
brown wire to a 12V(+) source.
Step 3: Momentarily connect the yellow
wire on a 12V(+) source to change flash
patterns.
Step 4: For left arrow function, connect the
blue wire to a 12V(+) post (switch). There
are 8 different left arrow flash patterns. To
select a pattern, engage the blue wire to a
12V(+) source and momentarily connect the
yellow wire on a 12V(+) source to select the
desired pattern.
Important Note! Takedown steady overrides
takedown flashing
6
F E NIE X .
2019
I NST RU CTI ON MA NUA L
WE B. w w w.feni ex .co m
Step 5: For right arrow function, connect
the gray wire to a 12V(+) post (switch).
There are 8 different right arrow flash
patterns. To select a pattern, engage the
gray wire a 12V(+) source and momentarily
connect the yellow wire on a 12V(+) source
to select the desired pattern.
Step 6: In order to achieve a center out
directional pattern, connect both the gray
and blue wires to a 12V(+) post (switch).
There are 8 different center out flash
patterns. To select a pattern, engage the
blue and gray wire to a 12V(+) source and
momentarily connect the yellow wire on a
12V(+) source to select the desired pattern.
Step 7: For takedown steady functionality,
connect the white wire to a 12V(+) post
(switch).
Step 8: For takedown flashing, connect the
green wire to a 12V+ (post).
TM
V3.0
Advertisement
