Getting Started - GE Profile OPAL 2.0 Owner's Manual
Hide thumbs
Also See for Profile OPAL 2.0:
- Owner's manual (56 pages) ,
- Owner's manual (56 pages) ,
- Owner's manual (60 pages)
Table of Contents
Advertisement
Available languages
Available languages
Getting Started
Installation Requirements
Lifting Hazard: It is recommended to have two people move and install the ice maker in order
CAUTION
to prevent injury.
your ice maker outdoors.
that is able to support the total weight when full of
water.
around the side and back walls of the ice maker for
proper air circulation.
Prepare Opal For Use
missing, please contact
3. Place the ice maker upright on a flat, level surface and
plug it in.
NOTICE
6
ovens or cooktops.
The tray slots should align with the front feet of Opal.
minutes before first use.
Making Ice
Add Water
Defrosting
Cleaning
Clean
Light
Power
Hold 3 Sec
49-9000029 Rev. 6
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Profile OPAL 2.0 and is the answer not in the manual?
Questions and answers
How can I replace the tubes?
To replace the tubes on a GE OPAL 2.0 ice maker:
1. Pull the sides up, pry from the back, and remove the covers.
2. Use pliers to remove the metal clips and hoses.
3. Press the clips on both sides to remove the reservoir lid.
4. Cut any zip ties attaching the hoses.
5. Remove the old tubing.
6. Install new clear tubing as a replacement.
7. Reattach any necessary clips and replace the zip ties.
Make sure to clean any buildup before installing the new tubes.
This answer is automatically generated
What does the blinking "Cleaning" light indicate during normal usage?
The blinking "Cleaning" light on the GE Profile OPAL 2.0 indicates that the unit requires cleaning.
This answer is automatically generated
I cleaned it but now water want go from side tank to ice maker
Water may not be flowing from the side tank to the GE Profile OPAL 2.0 ice maker due to one or more of the following reasons:
1. Incorrect Tube Connection: The tube labeled "Tube B" (marked "Side Tank") must be properly connected. If it's not correctly attached, water will not flow.
2. Air in the Line: If air is trapped in the tube, it can block water flow. Ensuring a proper seal and priming the line may help.
3. Water Not Drained First: If there's water already in the internal reservoir, the system may not draw from the side tank until the main reservoir level drops.
4. Side Tank Not Installed Properly: The tank must be seated correctly and connected tightly to ensure proper flow.
5. Clog or Debris: Blockages in the tube or connection point may stop water flow.
6. Ice Maker Turned Off: The ice maker should be turned off during setup and then turned back on once the side tank is connected.
Check all connections, ensure the tank is full and seated properly, and make sure the tubing is clear and correctly attached.
This answer is automatically generated