Technical Data; Before Starting The Equipment - EINHELL 45.136.50 Original Operating Instructions

4. Technical data

Motor supply voltage: ...............................12V DC
Idling speed: .......................................0-400 min
Torque settings: ........................................... 19+1
Clockwise/Counter-clockwise: ........................Yes
Clamping range of drill chuck: .......... max. 10 mm
Battery charge voltage: ....................... 13.5 V DC
Battery charge current: ................................ 0.5 A
Battery charger supply voltage: ............................
............................................100-240 V~ 50-60 Hz
Charging time: ..............................max. 3-5 hours
Battery type: ............................................... Li-Ion
Weight: ..........................................................1 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L sound pressure level ..................... 67,4 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 78,4 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Drilling in metal
Vibration emission value a
K uncertainty = 1.5 m/s
Screwing without hammer action
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Anl_TH_CD_12_Li_SPK9.indb 15 Anl_TH_CD_12_Li_SPK9.indb 15
GB
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
-1
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

≤ 2.5 m/s
2
h
Be sure to read the following information before
2
you put the cordless screwdriver into operation:
1. Charge the battery only with the charging unit
supplied.
≤ 2.5 m/s
2
h
2. Only ever use sharp drill bits and screwdriver
2
bits which are suitable for the purpose and in
faultless condition.
3. Always check for concealed electric cables
and gas and water pipes when drilling and
screwing in walls.
- 15 -
16.05.2022 14:44:36 16.05.2022 14:44:36