Amax AIR COMBAT PL-1170T User Manual

2.4ghz motion controlled battling helicopter

Advertisement

Quick Links

FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, CPSIA, FCC.
This product is manufactured by Amax Industrial Group China Co. Limited
Office No.3,10/F Witty Commercial Building 1A-1L Tung Choi street,
Mongkok. Kowloon Hongkong ©2023 All rights reserved.
2 Helicopters, 2 controllers, 2 USB chargers and replacement parts included.
11
2.4GHz Motion Controlled Battling Helicopter
WARNING: Never leave product charging unattended for extended periods
of time. Always disconnect helicopter from charger immediately after the
helicopter is fully charged. Please refer to enclosed safety instructions.
THIS PACKAGE CONTAINS:
Helicopter
Made in China
C011-USA-V1.0
AIR COMBAT
USER MANUAL
Remote Control
USB Charging Cord
Spare Rotor Blades
Colors and styles may slightly vary.
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AIR COMBAT PL-1170T and is the answer not in the manual?

Questions and answers

Summary of Contents for Amax AIR COMBAT PL-1170T

  • Page 1 Conforms to safety requirements of ASTM, CPSIA, FCC. helicopter is fully charged. Please refer to enclosed safety instructions. This product is manufactured by Amax Industrial Group China Co. Limited THIS PACKAGE CONTAINS: Office No.3,10/F Witty Commercial Building 1A-1L Tung Choi street, Mongkok.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS REMOTE CONTROL BATTERY INSTALLATION 1. Twist off the battery cover from the remote control. Features..................1 2.
  • Page 3: Preparing For Flight

    FLYING TIPS HELICOPTER DIAGRAM • Parental guidance or adult supervision is suggested at all times. • If you are flying the helicopter with others, make sure all spectators are behind you. SYNCING YOUR HELICOPTER Your Air Combat utilizes an automatic 2.4G channel selection system that allows up to 8 people to ™...
  • Page 4: Calibrating The Helicopter

    CALIBRATING THE HELICOPTER If the HELICOPTER becomes unstable during the course of flying, you may need to calibrate the internal gyros. To do this place the HELICOPTER on a flat level surface. press and hold the Calibrate button. The LEDs on the HELICOPTER will flash quickly and then remain solid, this indicates your drone has been recalibrated (see diagram F).
  • Page 5: Part Replacement Instructions

    PART REPLACEMENT INSTRUCTIONS REPLACING THE UPPER ROTOR BLADE CONTENTS: (1) upper rotor blade set (3) connecting rods Diagram Diagram (2) bottom rotor blade set (4) screws AIR COMBAT PROPELLER SYSTEM Using a screwdriver turn counterclock- Remove the broken blade and Your Air Combat propeller system is a precision instrument that may need repair or replacement from wise to remove the screw.
  • Page 6: Battery Warnings

    ALONG WITH THE ORIGINAL RECEIPT evidencing that the product was • Non-rechargeable batteries are not to be recharged. purchased from an approved AMAX retail partner and that the product is still within the 90 • Rechargeable batteries are to be removed from the item before being charged (if removable).

This manual is also suitable for:

Air combat pl-1170r

Table of Contents