Amax AC-1009 Instruction Booklet

Ultra micro heli with gesture control technology

Advertisement

Quick Links

FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Distributed by:
TRACTOR SUPPLY COMPANY
5401 VIRGINIA WAY
BRENTWOOD, TN 37027
For customer support,
call: 1-888-376-9601
www.TractorSupply.com
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, FCC and CPSIA.
Ascend Aeronautics™ is the registered trademark of Amax Group USA, LLC.
AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024
© 2021 All Rights Reserved. visit us at www.amaxbrands.com
11
ULTRA MICRO HELI
WARNING: Never leave product charging unattended for extended periods of time.
Always disconnect helicopter from charger immediately after the helicopter is fully
charged. Please refer to enclosed safety instructions.
THIS PACKAGE CONTAINS:
AC-1009
Remote Control
Made in China
C012-USA-V1.0
AC-1009
with Gesture Control Technology
INSTRUCTION BOOKLET
USB Charging Cord
Spare Rotor Blades
Colors and styles may slightly vary.
ARTWORK NO.
DESCRIPTION
IM.ai
110 x 173MM
Instruction
Booklet
MDSER
DESIGNER
DATE
Johnny

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC-1009 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Amax AC-1009

  • Page 1 Remote Control USB Charging Cord Spare Rotor Blades Instruction AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024 Booklet © 2021 All Rights Reserved. visit us at www.amaxbrands.com Made in China Colors and styles may slightly vary.
  • Page 2: Table Of Contents

    30-40 minutes( via 5.0V 2A USB wall charger). The helicopter operates for approximately 4 minutes per charge. Thank you for purchasing the AC-1009 2.4GHz Motion Controlled Helicopter. Please read this instruction booklet carefully as it contains valuable information on how to properly fly and care for your helicopter.
  • Page 3: Preparing For Flight

    • Fly only in a large room free of obstacles with an open radius of at least 25 feet.Close all windows and doors, turn off fans and close air ducts or any other openings that may cause drafts in the room. IMPORTANT:YOUR AC-1009 HELICOPTER IS DESIGNED FOR INDOOR USE ONLY.DO NOT FLY OUTDOORS. Stabilizer Bar...
  • Page 4: Calibrating The Ac-1009

    • Simply press the“Throttle wheel/start & land”down on the controller,your AC-1009 will automatically take off. • To stop or land the AC-1009 just press the“Throttle wheel/start & land”down again and the AC-1009 will descend and land automatically. Tilt the controller left and the helicopter will spin counterclockwise.
  • Page 5: Part Replacement Instructions

    PART REPLACEMENT INSTRUCTIONS REPLACING THE UPPER PROPELLER BLADE CONTENTS: (1) 2 upper propeller blade (3) 4 connecting rods Diagram Diagram (2) 2 bottom propeller blade (4) 4 screws GYRO-STABILIZED 3CH WIRELESS INDOOR HELICOPTER PROPELLER SYSTEM Using a screwdriver turn counter Remove the broken blade and Your Gyro-Stabilized 3CH Wireless Indoor Helicopter propeller system is a precision instrument that clockwise to remove the screw.
  • Page 6: Helicopter Warning And Safety Precautions

    • Keep hands,hair,and loose clothing away from the propeller when the power switch is turned to warranty center ALONG WITH THE ORIGINAL RECEIPT evidencing that the product was purchased from an approved AMAX retail partner and that the product is still within the 90 the ON position.

This manual is also suitable for:

Ultra micro heli ac-1009

Table of Contents