Amax Voyage Aeronuatics PA-1009 Instruction Booklet

Amax Voyage Aeronuatics PA-1009 Instruction Booklet

Ultra micro heli with gesture control technology

Advertisement

Quick Links

FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, FCC and CPSIA.
Voyage Aeronuatics™ is the registered trademark of Amax Group USA, LLC.
AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024
© 2020 All Rights Reserved. visit us at www.amaxbrands.com
11
ULTRA MICRO HELI
WARNING: Never leave product charging unattended for extended periods of time.
Always disconnect helicopter from charger immediately after the helicopter is fully
charged. Please refer to enclosed safety instructions.
THIS PACKAGE CONTAINS:
PA-1009
Remote Control
Made in China
C011-USA-V1.0
PA-1009
with Gesture Control Technology
INSTRUCTION BOOKLET
USB Charging Cord
Spare Rotor Blades
Colors and styles may slightly vary.
ARTWORK NO.
DESCRIPTION
IM.ai
110 x 173MM
Instruction
Booklet
MDSER
DESIGNER
DATE
Johnny

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Voyage Aeronuatics PA-1009 and is the answer not in the manual?

Questions and answers

Summary of Contents for Amax Voyage Aeronuatics PA-1009

  • Page 1 THIS PACKAGE CONTAINS: Conforms to safety requirements of ASTM, FCC and CPSIA. Voyage Aeronuatics™ is the registered trademark of Amax Group USA, LLC. AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024 PA-1009 Remote Control USB Charging Cord...
  • Page 2 TABLE OF CONTENTS CHARGING THE REMOTE CONTROL Features..................1 1.
  • Page 3 HELICOPTER DIAGRAM PREPARING FOR FLIGHT Below is a basic list of features and parts on the helicopter. • Verify that there are the helicopter and remote control has been fully charged. • Make sure your helicopter is turned on and properly synced to your remote control (See “SYNC YOUR HELICOPTER” below). •...
  • Page 4 CALIBRATING THE PA-1009 If the PA-1009 becomes unstable during the course of flying, you may need to calibrate the internal gyros. To do this place the PA-1009 on a flat level surface. Long press calibrating button. The LEDs on the PA-1009 will flash quickly and then remain solid, this indicates your helicopter has been recalibrated (see diagram F).
  • Page 5 PART REPLACEMENT INSTRUCTIONS REPLACING THE UPPER PROPELLER BLADE CONTENTS: Diagram Diagram (1) 2 upper propeller blade (3) 4 connecting rods (2) 2 bottom propeller blade (4) 4 screws GYRO-STABILIZED 3CH WIRELESS INDOOR HELICOPTER PROPELLER SYSTEM Using a screwdriver turn counter Remove the broken blade and clockwise to remove the screw.
  • Page 6 • Turn off the transmitter and helicopter power switches when not in use. purchased from an approved AMAX retail partner and that the product is still within the 90 • The charging cable is for charging the helicopter’s Li-poly battery. Do not use it to charge any other battery.

Table of Contents