Garland GRASS 1265 ZSBW Instruction Manual page 44

English
Two lights - 33% to 54%
One light - 10% to 32%
Flashing light - less than 10%
6.3.3. START THE ENGINE
STAR
RUN
0
1
4. Once started, put the accelerator lever in the
position between MIN and MAX and let the motor
warm up.
5. To start work, bring the throttle lever to the MAX
position.
NOTICE: To extend the life of the starter, use short
starting cycles (five seconds maximum). Wait one
minute between starting cycles.
NOTICE: If the engine does not start after repeated
attempts, contact a Servicing Dealer.
1. Mount the battery
3
(3) in the battery
tray on top ofengine.
Make sure battery
pack is securely
installed.
2. Put the
accelerator lever in
the MAX position.
3. Hold the engine
stop lever against
the handle. Then,
turn the electric start
key to the I position.
44/172
6.4. STOPPING THE ENGINE
Turn of the engine by releasing the safety switch.
STOP
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.