To Remove Base; Base Installation With Vehicle Belt - Baby Trend Secure 35 Owner's Manual

10.0 Securing Car Seat in Your Vehicle
9. Check that the base is tightly installed and
stays tightly installed by grasping the base
near the belt path and trying to move side-to-
side (Fig 39-1). If LATCH belt loosens or that
the or the base does not stay tightly secured,
please see Section 8.0 Selecting the Best
Location for the Car Seat to determine if the
position you have selected is adequate and
check that you have completed all of the steps in the section entitled
Securing the Car Seat or Base in the Vehicle. DO NOT use this
seating location if the Car Seat does not remain tightly installed in the
vehicle seat!

10.2.3 To Remove Base

Disconnect LATCH Lower Connectors.
To disconnect the LATCH Connectors:
1. Push base toward LATCH connectors and
while pushing on the base, press the RED
LATCH Release Button in the base belt
path (Fig 39-2).
2. Press the RED LATCH Release Button on
one of the LATCH Connectors (Fig 39-3)
and pull base away from the
vehicle anchors.
39
39-1
39-2
LATCH Release
Button
39-3
Copyright © 2021, Baby Trend, Inc.
10.0 Securing Car Seat in Your Vehicle
3. Repeat on opposite side.
4. Return LATCH connectors to storage
position on side of base.
5. Pull downward on LATCH belt end loops to
remove excess belt from LATCH system.

10.3 Base Installation with Vehicle Belt

WARNING!
DEATH or SERIOUS INJURY can occur:
VEHICLE LAP BELT MUST BE TIGHTLY ADJUSTED AND STAY TIGHTLY
ADJUSTED AROUND CHILD RESTRAINT AT ALL TIMES. IF VEHICLE
BELT DOES NOT STAY TIGHT, READ VEHICLE OWNER'S MANUAL AND
"VEHICLE SEAT BELT REQUIREMENTS" SECTION IN THIS MANUAL.
PROPER RECLINE ANGLE FOR SEAT BACK RECLINE IS REQUIRED.
FOLLOW THE INSTRUCTIONS FOR ADJUSTING RECLINE ANGLE
USING SEAT ANGLE INDICATOR.
- TOO UPRIGHT CAN CAUSE A YOUNG INFANT'S HEAD
TO FALL FORWARD AND RESTRICT BREATHING.
- TOO RECLINED CAN CAUSE EJECTION IN A SUDDEN STOP
OR CRASH.
Copyright © 2021, Baby Trend, Inc.
40