Removing The Mower - Toro 78292 Operator's Manual

3. Pull the height-of-cut lever out to disengage it from the
quadrant (Fig. 23).
1
5
Figure 23
1. Height-of-cut lever
2. Quadrant
3. High
4. Adjust the height-of-cut to the desired level (Fig. 23).
5. Release the lever inward to lock it into the quadrant
(Fig. 23).
3
4
2
m–3474
4. Low
5. Medium position

Removing the Mower

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Lower the mower.
4. Remove the washer (3/4 inch) and a hairpin cotter from
the attachment lift pin into the slot in the center lever
bar (Fig. 5).
5. Open the mid-mount hitch by pulling out the J–pin and
moving the lock handle rearward (Fig. 24).
6. Turn the right knob on the front pulley box to loosen the
mower drive belt (Fig. 9).
7. Remove the mower drive belt from the mower
(Fig. 10).
8. Remove the mower drive belt from the lower pulley and
lower idler pulley in the pulley box (Fig. 10).
9. Turn the front wheels fully to the left and raise the
attachment lift lever or electric lift all the way up.
1
1. Front hitch
2. Mid-mount hitch
10. Slide the mower from under the chassis to the right side
of the tractor (Fig. 5).
11. If needed, remove the pulley box by pushing on the
release lever and removing the pulley box (Fig. 24).
12
Figure 24
3. J–pin
4. Lock handle
4
2
3
m–6622