Toro 78292 Operator's Manual page 6

6. Slide the mower under the tractor from the right side
and slide the attachment lift between the center and left
side level bar (Fig. 5).
7. Straighten the front wheels and lower the attachment lift
lever or electric lift to the mounting position; refer to
the tractor Operator's Manual.
8. Place the attachment lift pin into the slot in the center
lever bar and secure it with a washer (3/4 inch) and a
hairpin cotter (Fig. 5).
6
Figure 5
1. Attachment lift
2. Slot in center level bar
3. Washer
9. Rotate the front mounting shaft so the fork faces
straight up and aligned so the spacers are between the
mid-mount hitch plates (Fig. 6).
10. Lift the mower with the attachment lift lever or electric
lift and guide the fork to capture the hitch rod (Fig. 6).
11. Close the mid-mount hitch lock handle by rotating it
forward (Fig. 4).
1
5
2
3
4
m–2824
4. Hairpin cotter pin
5. Left level bar
6. Right footrest
4
Figure 6
1. Front mounting shaft
2. Fork
3. Spacer
Installing the Front Pulley Box
Install the front pulley box if it is not already installed.
1. Rotate the knobs to adjust the idler pulleys so there is a
1/4 inch (7 mm) clearance between the idler arms and
the mounting pins.
4
2
1
3
Figure 7
1. Mounting Pins
2. Idler arm
2. Make sure the front latches are open and then slide the
pulley box into the front hitch.
Note: Make sure the pulley box engages and closes the
latches.
3. Adjust both idler pulleys until they are totally to the
outside by turning the knobs.
6
5
2 3
3 m–2825
4. Mid-mount hitch plate
5. Hitch rod
4
1
3
2
m–6621
3. 1/4 inch (7 mm) clearance
4. Knob
1