Table of Contents
Advertisement
Date and Time Display
Date and Time Display
Install the Clock Lithium Cell
The clock cell indicator
you turn on the camcorder if the cell is not installed or needs replacing.
Clock Cell
Compartment
Clock Cell
Holder
1. Make sure camcorder is turned off,
and remove any power supply
attached to the camcorder.
2. Pull the clock cell holder out of the
clock cell compartment.
3. Insert the clock cell with the "+"
terminal facing out, and press it in.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such
as CR2025. Use of other cell presents a risk of fire or explosion. Must be
disposed of properly. Never handle punctured or leaking cell. May cause
burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If
swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or
incinerate.
Never use metallic tweezers to hold the cell, and never short the + and – sides
of the cell.
flashes for a few seconds in the viewfinder when
Clock Cell
(+ Side Facing Out)
4. Place the clock cell holder into the
To Remove Lithium Cell
To remove battery, insert a pointed
nonmetallic object between battery and
clock cell holder and lift.
clock cell compartment. Be sure to
insert the holder fully into the
compartment.
Insert Object Here
to Remove Cell
17
Hide quick links:
Advertisement
Table of Contents
