Yamaha KX-690 Owner's Manual page 7

‹
⁄ @ ¤ #
S L
REMAIN m TAPE
dB –30 25 20 17 14 12 10
R
REPEAT 0-M FULL
BCS MPX FILTERSYNCHRO REC TAPE TUNING INTRO ¤‹ I/NORM II/HIGH IV/METAL
MEMORY TAPE SOURCE
COUNTER MEMORY REPEAT
RESET REMAIN TAPE OFF/O–M/FULL
PHONES BIAS ADJUST PLAY TRIM
LEVEL
0 0
0 10 — + — +
· (
° *
fl
MUTE/SEARCH button
During Recording (MUTE):
When the MUTE/SEARCH button is pressed during
recording, a 4-second blank interval is automatically
recorded onto the tape (Auto Rec Mute mode).
During Playback (SEARCH):
By pressing the MUTE/SEARCH and ⁄ buttons
simultaneously, the tape will advance to the beginning of
the next selection and begin play.
By pressing the MUTE/SEARCH and ! buttons
simultaneously, the tape will rewind to the beginning of the
current selection and begin play.
&
REC/PAUSE button
Pressing this button engages the Rec/Pause mode. In this
mode, the PEAK level meters will function, allowing you to
monitor and set the recording signal level of the deck.
‡
REC BALANCE and REC LEVEL controls
Adjust the recording levels for the left and right channels
with the REC BALANCE control.
Adjust the recording level so that the highest peak may
not exceed the optimum levels with the REC LEVEL
control.
*
PLAY TRIM control
With this control, the compatibility between this unit and
tapes recorded on another deck is increased. During
playback turn this control to the right to boost high
frequencies or turn it to the left to attenuate them.
°
BIAS ADJUST control
This control is for fine adjustment of the recording bias.
Turning the control counterclockwise decreases the bias
and will result in recordings with boosted high
frequencies. Too little bias can result in too much or
distorted high frequencies. If less distortion is more
important than high frequencies, turn the control
clockwise to increase the bias signal.
%
$ ›
DOLBY B·C·S NR HX PRO
DOUBLE DOLBY SYSTEM
STOP
8 6 4 2 0 2 4 6 8+
¤ INTRO SCAN ‹
¤¤
AUTO TAPE
TUNING
REC
BALANCE LEVEL
0 5
1 1 4 6
REC/PAUSE
2 2 3 7
3 3 2 8
4 4 1 9
L 5 5 R 0 10
‡
&
fi ^
PLAY
‹‹
MUTE/SEARCH
fl
(
LEVEL control
Use this control to adjust the output level at the PHONES
jack. Turn the control to the clockwise to increase, or
counterclockwise to decrease, the output level.
·
PHONES jack
Connect headphones to this jack for monitoring recording
or playback.
)
EJECT button
Press this button to open the cassette compartment.
The button will not function if the deck is in Play, Record
or Record/Pause mode.
‚
DOLBY NR buttons
OFF/ŸB/ŸC/ŸS:
When playing tapes encoded with Dolby NR or making
recordings to be encoded with Dolby NR, set this switch
to the desired type of Dolby noise reduction.
MPX OFF/MPX ON:
Press this switch to the ON position when recording
broadcasts from FM stations while using a Dolby NR
system.
Set this switch to OFF when recording sources other than
FM broadcasts, and during playback of any tape, even a
recording of an FM broadcast.
_
MONITOR button
Set this switch to the source monitor mode to monitor the
sound to be recorded. Set this swtich to the tape monitor
mode to monitor the recorded sound.
7