Table of Contents
Advertisement
Problem
There is water on the floor.
You cannot open the appli-
ance lid.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the appliance shows other alarm codes (the
indicator of button
TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against
moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
•
Make sure that the couplings of the water hoses are tight and there
is not water leakages.
•
Make sure that the drain hose have no damages.
•
Make sure you use the correct detergent and the correct quantity of
it.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion'.
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation'.
•
Add more laundry in the drum. The load may be too small.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you
wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Make sure that you press only the wanted button(s).
flashes in red). Deactivate
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Possible solution
and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
400 mm/ 890 mm/ 600 mm/ 600 mm
220-230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
6 kg
A+
15
Advertisement
Table of Contents
