Cabling - Medion AKOYA E1228 Manual

Cabling


Arrange cables so no one can walk on or trip over them.

Do not place objects on any of the cables.

Do not allow any large forces to be exerted on the plug-in connections, from the
side, for example. This will otherwise lead to damage to and in your device.

Do not exert any force when connecting cables and plugs and pay attention to the
correct orientation of each plug.

Pull the connection at the plug, not at the cable, of you are detaching a connection
cable from your device.

Avoid short circuits and cable breaks by not squeezing the cable or bending it
sharply.

To avoid damage to your netbook, connect your peripherals (e.g., keyboard,
mouse and monitor) whilst your netbook is powered off. Some devices can be
connected whilst your netbook is in use. These devices usually have a USB
connector. Please follow the appropriate instructions for each device.

Keep the netbook at least one meter (approximately three feet) away from high
frequency and magnetic interference sources (e.g., televisions, loudspeaker
cabinets, mobile telephones, etc.) in order to avoid malfunctions and/or loss of
data.

Please note that only shielded cables shorter than
3 metres (9.84 ft) should be used for the LPT, COM, USB, IEEE 1394, audio, video
and network interfaces with this netbook. Please use only doubly screened cables in
the case of printer cables.

Do not replace the cables supplied. Only use the cable supplied with the netbook,
since that cable will have been tested extensively in our laboratory.

Also only use the connection cables supplied with the devices to connect your
peripherals.

Make sure that all connecting cables are connected with the respective peripheral
devices, in order to avoid perturbing radiation. Remove any cables not needed.

The connection of devices is limited to equipment that complies with EN60950
"Safety of information technology equipment" or EN60065 "Audio, video and
similar electronic apparatus. Safety requirements".
8 English