Table of Contents
Advertisement
A
CAUTION:
machine! Otherwise, the product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the washing machine
needs to be moved again in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.4.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa).
It is necessary to have 10 – 80 liters of water flowing from the fully open tap in one minute to
have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher.
A
CAUTION:
In such a case the laundry will get damaged or the product will switch to protection mode and
will not operate.
CAUTION:
stains on your laundry.
1
Tighten the nuts of the hose by hand. Never use a tool when tightening the nuts.
2
When hose connection is completed, check whether there is leak problems at the
connection points by opening the taps fully. If any leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after checking the seal. In order to prevent the water
leaks and resultant damages, keep the taps closed when you do not use the product.
Washing Machine / User's Manual
Remove the transportation safety bolts before operating the washing
Models with a single water inlet should not be connected to the hot water tap.
Do not use old or used water inlet hoses on the new product. It may cause
13 / EN
Advertisement
Table of Contents
