Adding Detergent And Care Products; Starting The Program; Soaking Laundry; Adding Laundry - Bosch WAX32MX2 Instructions For Use And Assembly

Fold down the dispensing aid and
3.
click into place.
Slide in the detergent drawer.
4th
13.7 Adding detergent and care
products
Hints
¡ Use the dosing aid for liquid
Do not use sigwaschmittel with gel-
type detergents, washing powder,
activated prewash or ready-in-time.
¡ Observe the notes on
Detergents and care products
→ Page 31 .
Pull out the detergent drawer.
1.
Pour in the detergent.
2.
→ "Detergent drawer ",
page 20
If necessary, fill in the care product.
3.
Slide in the detergent drawer.
4th
13.8 Start the program
Notice: If you want to change the
time until the end of the program,
set the feet first
on Start / reload
▶
ready in-time.
n
to press.
Basic operation de
a The drum turns and it
A load detection follows, which can
take up to 2 minutes and then the
water runs in. a The display shows
either pro
duration or the Ready in time is
displayed.
a The display shows after program
end: -0-.

13.9 Soaking laundry

Notice: No additional detergent is
necessary. The washing liquor is
then used for washing.
Start the program.
1.
To pause the program, open after
2.
approx. 10 minutes Start / reload
To continue the program, click on
3.
after the desired soaking time
Start / reload to press.

13.10 Adding laundry

on Start / reload
1.
The device pauses.
Notice: If appears, it is not possible
to add laundry.
When goes out, it is possible to add
laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4th
on Start / reload
5.
13.11 Cancel the program
on Start / reload
1.
Open the appliance door.
2.
At high temperatures and high
water levels, the door remains
locked for safety reasons.
to press.
to press.
to press.
to press.
33