Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ELICA Como Series
Summary of Contents for ELICA Como Series
- Page 1 Use, Care, and Installation Guide READ AND SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
Contents page English Contents Important safety Notice ..............................3 Electrical & Installation requirements ........................4 Electrical requirements ....................................4 Before installing the hood ....................................4 List of Materials................................5 Parts supplied .........................................5 Parts not supplied......................................5 Dimensions and Clearances............................6 Ducting Options and Examples..........................7 Venting methods ......................................7 Preparation ........................................7 Installation ...................................8 Installation - Ducting version....................................8... -
Page 3: Important Safety Notice
READ AND SAVE THESE INSTRUCTIONS Important safety Notice WARNING CAUTION TO REDUCE THE RISK OF INJURY TO PERSONS, IN FOR GENERAL VENTILATING USE ONLY. DO NOT USE THE EVENT OF A RANGE TOP GREASE FIRE, EXHAUST HAZARDOUS EXPLOSIVE OBSERVE THE FOLLOWING: MATERIALS OR VAPORS. -
Page 4: Electrical & Installation Requirements
Electrical & Installation requirements Electrical requirements Before installing the hood 1. For the most efficient air flow exhaust, use a straight run IMPORTANT or as few elbows as possible. Observe all governing codes and ordinances. CAUTION: Vent unit to outside of building, only. It is the customer’s responsibility: 2. -
Page 5: List Of Materials
List of Materials Parts supplied Parts not supplied Removing the packaging Optional Accessories CAUTION! • Ductless Recirculating Kit Remove carton carefully, Wear gloves to protect against To be used only in the Ductless (Recirculating) sharp edges. version includes: charcoal filter, charcoal filter support and WARNING! fixing bracket, deflector Remove the protective film covering the product before... -
Page 6: Dimensions And Clearances
Dimensions and Clearances... -
Page 7: Ducting Options And Examples
Ducting Options and Examples Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Venting methods The hood is equipped with a transition B for discharge of fumes to the outside (Ducting version). Should it not be possible to discharge cooking fumes and vapour to the outside, the hood can be used in the Ductless (Recirculating) version. -
Page 8: Installation
Installation Installation - Ducting version • If possible, disconnect and move freestanding or slide-in dependig on the elbow used) above the pencil line that range from cabinet opening to provide easier access to indicates the bottom installation height, to the circle rear wall. - Page 9 • Remove the hood. • Drive “lower” wood screws, by hand. Remove screws. • Mount the hood onto the “upper” screws. • Drive and tighten the “upper” wood screws, by hand. • Drive and tighten the “lower” wood screws, by hand. Mounting the hood WARNING: 2 people are required to lift and position the hood onto the mounting screws.
- Page 10 Connecting the ductwork • If not already done, install 1/2” conduit connector in j- • Install ductwork, making connections in the direction of box. airflow as illustrated. • Push duct over the exhaust outlet. • Wrap all duct joints and the flange connections with duct tape for an airtight seal.
- Page 11 Mounting the duct cover If range hood does not operate: • Position the duct cover over the mounted hood. • Check that the circuit breaker is not tripped or the house • Slide the bottom of the duct into the canopy area. fuse blown.
-
Page 12: Installation - Ductless (Recirculating) Version
Installation - Ductless (Recirculating) version If ductwork will vent to rear: CAUTION • Use a level to draw a line straight up from the centerline To install the hood in this version, first purchase the on the template. Ductless Recirculating Kit. •... - Page 13 • Remove the hood. • Drive “lower” wood screws, by hand. Remove screws. • Mount the hood onto the “upper” screws. • Drive and tighten the “upper” wood screws, by hand. • Drive and tighten the “lower” wood screws, by hand. Mounting the hood WARNING: 2 people are required to lift and position the hood onto the mounting screws.
- Page 14 Connecting the ductwork Electrical connection • Install ductwork, making connections in the direction of airflow as illustrated. WARNING • Push duct over the exhaust outlet. Electrical Shock Hazard • Wrap all duct joints and the flange connections with duct Warning: Turn off power circuit at the service panel before wiring this unit.
- Page 15 Mounting the glass canopy • Secure the bottom of the duct with 2 assembly screws provided. • With the hood mounted on the wall slide the glass canopy over the glass supports. • Insert the glass brackets. • Insert two screws into the bracket holes, drive the screws by hand.
-
Page 16: Description Of The Hood & Controls
Description of the hood & Controls 1. Blower and light controls 2. Lamp housings 3. Grease filter Handle 4. Grease filter 5. Canopy 6. Duct covers 7. Louver holes (Only for Recirculating version) -
Page 17: Controls
5. “+” Button. Speed Increase / ON Controls • This button is used to increase the fan speed, or turn Use the high suction speed in cases of concentrated kitchen ON the fan. vapours. It is recommended that the cooker hood suction is •... - Page 18 Charcoal filter inclusion and exclusion (Recirculating accessories) • The charcoal filter inclusion or exclusion can be set by pressing the “+” and “-” buttons at the same time for 5 seconds. • The Inclusion or exclusion of charcoal filter must be selected while the lamps and the motor are OFF.
-
Page 19: Maintenance
Maintenance ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance...
Need help?
Do you have a question about the Como Series and is the answer not in the manual?
Questions and answers