Install The Transport Aid; Transport And Storage; Operation; Start And Stop The Implement - Hyundai WR8020-1050-P-360H1 Manual

8.4 Install the transport aid

12
19
18
20
● Remove the pre-assembled split pin (20) and the
washer (18). Place the wheel (16) on the whee
holder (19). Secure it with the washer (18) and
the split pin (20). Then mount the wheel cap (17).
(fig. 12,13)
(Assembly is identical on both sides)

8.5 Transport and storage

10
17
21
16
● Always pull out the power cord before
transporting!Pull the lock pin (21). You can now
move the wheels (16) to the lower position. Make
sure that the lock pin (21) engages again in the
lower position. (fig. 13)
● Attention! The wheels must be fixed in the upper
position during operation! (fig. 10)
● For storage or transport in a limited space,
proceed as follows:Open the wing nuts (09) until
you can fold the handles forward.
Attention! Danger of crushing your fingers.
● Now you can transport your machine with the
transport handle (03).
So you can storage the machine too.
13
21 17 16
13
21 17 16
E NGLISH

9. OPERATION

9.1 Start and stop the implement

7
11
12
● Repeat this process several times so that you
are sure that the machine functions properly.
Before you perform any repair or maintenance
work on the machine, ensure that the cutting unit
is not rotating ano that the power supply is
disconnected.
● The safety distance between housing and user
giver by the handle (01) must always be observed.
Be especially careful when digging and changing
direction or slopes and inclines. Maintain a solid
footing and wear sturdy, non-slip footwear and
long trousers. Always dig along the incline (not up
and down).
● For safety reasons, the Electric Tiller may not be
used to dig up inclines whose gradient exceeds
15 degrees. Use special caution when backing up
and pulling the implement (tripping hazard)!

9.2 Tips for proper working

Always guide the machine slowly and wisely
forward Dia up the area in straiaht lines. Let the
tracks overlap slightly to not miss any stripes to dig.
Only use the machine to diq up already loosened
soil
08
25
● To prevent an
accidental start-up of
the implement, the
throttle handle (01) is
equipped with a safety
release switch (11)
which must be pressed
before the On/Off
switch (12) can be
pressed. If the On/Of
switch (12) is released,
the equipment switches
off.