User Interface - Chamberlain LIF-STAR1000 Instruction Sheet

USER INTERFACE

The STAR1000 user interface consists of a 22 character by 5 line LCD
display, 3 "soft keys", Down/Up arrows and a numeric keypad.
Scroll Indicator
If more than 3 options exist, a scroll
indicator appears on the left margin of
lines 2, 3, and 4. The scroll indicator
shows the relative position within the list.
Line 1:
Menu and function mode.
Lines 2, 3, and 4:
Menu selections and data.
Line 5:
Soft key function modes.
PROGRAMMING
The receiver has the ability to learn a combination of remote control
transmitters and keyless entries up to 1,000 devices. See page 4 for a
complete list of compatible accessories. Audible and visual warnings
occur when the receiver capacity is exceeded. After 30 seconds of
inactivity, the receiver times out and the LiftMaster
Select "UNLOCK" and enter the PIN to continue.
Initial PIN set up:
The PIN restricts access to authorized administrators only. If you omit
this step, anyone will be able to program the receiver. Upon initial power
up, the system firmware revision is displayed for 5 seconds followed
by the LiftMaster ® logo. When a key is pressed, "CREATE PIN?"
is displayed.
1. Press "YES" to create PIN.
2. If the PIN is lost you may request a reset code by pressing "RESET."
You will be provided with a 5 digit serial number. Login to partner
portal and go to https://partner.liftmaster.com/utility.
Enter the Serial Number to retrieve the master code.
Antenna Connection
For the direct antenna or
the antenna extension kit.
® logo is displayed.
3. Enter a 6-digit PIN, and press "YES"; enter the 6-digit PIN a second
4. When your 6-digit PIN is programmed correctly, the LCD display
2
Once master code is retrieved, come back to the RESET option, and
after obtaining the serial number press Next.
Enter the master code from the partner portal.
Enter the new PIN.
Re-Enter the new PIN. You will hear a beep from the unit when the PIN
has been successfully programmed.
Note: Resetting the PIN does not clear data or settings on the
STAR1000 and PPWR. 6
time and press "YES" to program the PIN. If you make a mistake,
press "CLEAR" to change your entry. To exit the enter PIN screen,
select "BACK".
reads "KEYPAD UNLOCKED". Select "OK" to continue to the Main
Menu. After 30 seconds of inactivity, the receiver times out and
®
the LiftMaster logo is displayed. Select "UNLOCK" and enter PIN
to continue.
Menu/Data selection
shown in inverse font.
LCD Screen
System
programming and
status display.
"SOFT" Keys
Soft key functions
are defined by the
label on line 5 of the
display. The
functions change
according to the
menu selection.
Down/Up Keys
For navigation in
the menus.
Numeric Keypad
Numeric data is
entered through the
numeric keypad.
Insert wiring