Daikin FTXS42K2V1B Operation Manual page 15

Adjusting the Airfl ow Direction
and Rate
NOTE
■
Notes on the angles of the fl aps
• The fl ap swinging range depends on the operation. (See the fi gure.)
COOL and
DRY operation
Stop operation
35°
COMFORT
AIRFLOW
Upper limit
40°
90°
Lower limit
• In swing operation during cooling operation, the upper fl ap does not move. This is not malfunction.
When swing operation is stopped, the upper fl ap angle changes according to the lower fl ap angle.
■
Note on the angles of the fl aps
• Using 3-D airfl ow circulates cold air, which tends to collect at the bottom of the room, and hot air, which tends to collect near the ceiling,
throughout the room, preventing areas of cold and hot developing.
■
Note on airfl ow rate setting
• At smaller airfl ow rates, the cooling (heating) effect is also smaller.
CAUTION
• Always use a remote controller to adjust the angles of the fl aps and louvers. If you attempt to move the fl aps and louvers forcibly with hand
when they are swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers angles. Inside the air outlet, a fan is rotating at a high speed.
■
To adjust the airfl ow rate setting
Press .
• Each pressing of
Auto
High
• When the airfl ow is set to "
from the unit will become quieter.
• In indoor unit quiet operation, the airfl ow rate is set to a weak level.
• If the temperature does not reach the desired point, change the airfl ow rate setting.
• In DRY mode, the airfl ow rate setting is not variable.
HEAT operation
Stop operation
60°
Upper limit
95°
Lower limit
advances the airfl ow rate setting in sequence.
Indoor unit quiet Low
Middle high Middle
", indoor unit quiet operation will start and the noise
FAN operation
Stop operation
100°
COMFORT AIRFLOW
Middle low
Upper limit
40°
90°
Lower limit
14