Eterna OH211 Safety And Installation Instructions

CLEANING:
• Always remove the plug from the electrical socket and allow the heater to cool down before cleaning
the heater.
• Wipe heater with a soft dry cloth.
• Wind the cable around the cable tidy and store the heater in a clean dry place.
• Do not try to repair the heater yourself, always consult a suitably qualified engineer.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet.
EVENTUALLY, YOU MAY WANT TO REPLACE THIS HEATER:
New regulations require the recycling of Waste from Electrical and Electronic Equipment (European
"WEEE Directive" effective August 2005—UK WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/GA0248QZ.
When your heater comes to the end of its life or you choose to replace it, do not dispose of it with your
normal household waste. Please recycle where facilities exist. Check with your supplier or local authority
for suitable options.
IF YOU EXPERIENCE PROBLEMS:
If your heater is defective or develops a fault, please return it to the place where you bought it. You
can call our helpline for advice. The helpline will gladly give advice on any aspect of any Eterna heating
product.
SPECIFICATION:
VOLTAGE: 220 – 240V – 50Hz
POWER MAX: 2kW
HELPLINE:
• T: 01933 673 144
• F: 01933 678 083
• E: sales@eterna-lighting.co.uk
Visit our website:
www.eterna-lighting.co.uk
SAFETY AND INSTALLATION INSTRUCTIONS
Model:
OH211
2kW 11 Fin Oil Filled Heater
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR HEATER
PLEASE RETAIN FOR FUTURE REFERENCE
Pack contents:
Oil filled heater c/w 13A. fused, Qty. 1
3 pin plug fitted
Heater wheel clamping plates Qty. 2
Castor wheels Qty. 4
Dome nuts Qty. 4
U clamping bolts Qty. 2
U clamp securing wing nuts Qty. 4