Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mopec BK225
Summary of Contents for Mopec BK225
- Page 1 MOPEC USER MANUAL SLIDE DRYING MINI WORKSTATION - BK225...
-
Page 2: Table Of Contents
WARRANTY TERMS AND CONDITIONS INTRODUCTION Mopec’s Slide Drying Mini Workstation for Flotation Baths was specifically designed to fit directly over our Illuminated Tissue Flotation Bath and take up minimal bench-top space. This workstation features a mini hotplate to remove wrinkles from tissue sections as well as a sloped drying area that holds up to 12 slides. -
Page 3: Specimen Safety
4. Before using any cleaning or decontamination method please refer to the Maintenance and Cleaning section to ensure the proposed method will not damage the unit. 5. Connect only to a power supply with the corresponding voltage to that specified on the rating label positioned on the rear of the unit. -
Page 4: Power Lead & Connection To Electrical Supply
Before use, check voltage is compatible with supply. SPECIFICATION The Mopec Slide Drying Mini Workstation is designed to dry paraffin tissue sections efficiently whilst taking up a minimum of bench space in the laboratory. The hotplate features a matte black heated surface which is digitally controlled at a constant temperature. -
Page 5: Location
Both switches should be set to correct mains voltage for your region. The voltage can be changed by removing the security plate. 2. The Slide Drying Mini Workstation is designed to be used in conjunction with the Mopec instruments: a. -
Page 6: Cleaning Instructions
3. Connect the mains plug to the electrical supply and switch on - ensure the power supply is properly earthed. 4. Turn on the hotplate. 5. Select the desired temperature. a. Press the DOWN arrow then release it (do not hold DOWN arrow for 5 seconds). b. -
Page 7: Miniature Circuit Breakers
Portable appliance testing should be carried out by a qualified person. THIS EQUIPMENT MUST NOT BE FLASH TESTED! WARRANTY TERMS AND CONDITIONS 1. Mopec warrants to the Customer that the product purchased is free from defects in materials and workmanship. - Page 8 4. Mopec will accept no liability, where in the opinion of the company the defect has been caused by damage due to the Customers failure to follow operating instructions, correct...
- Page 9 It is the customers responsibility to ensure that the loan equipment is packed in the packaging provided by Mopec, in order that Mopec can arrange collection of the loan instrument. If the loan instrument is not packed and ready for collection within 48 hours of a repaired instrument being returned to the customer, costs for collection and equipment rental fee will be applied.
- Page 10 Electrical equipment for measurement control and laboratory use - EMC requirements. ROUTINE INSPECTION RECOMMENDATIONS Mopec recommends that a simple annual inspection be made for all Mopec laboratory appliances in order that any malfunction can be identified and rectified as early as possible. This is to ensure user safety and prolong instrument lifespan.
Need help?
Do you have a question about the BK225 and is the answer not in the manual?
Questions and answers