Table of Contents
Advertisement
Quick Links
4 Video Transmit Unit with Bi-directional Data Channel
The AMG4643-SF is a standalone zero channel video transmit unit designed to transmit 4 video
signals and transmit and receive 1 data signal over one Multimode fibre.
The AMG4643-SF is designed to be powered using an AMG2003 standalone power supply.
The AMG4643-SF is designed to operate with AMG4644-SF or rackmount equivalent AMG4644R-SF
zero channel video receive unit in a point to point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
AMG4643-SF
Instruction Manual
Page 1 of 8
AMG4643-SF Instruction Sheet
D16596-03.doc
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AMG AMG4643-SF
Summary of Contents for AMG AMG4643-SF
- Page 1 Instruction Manual 4 Video Transmit Unit with Bi-directional Data Channel The AMG4643-SF is a standalone zero channel video transmit unit designed to transmit 4 video signals and transmit and receive 1 data signal over one Multimode fibre. The AMG4643-SF is designed to be powered using an AMG2003 standalone power supply.
-
Page 2: Table Of Contents
Removal / replacement from / to the Case..................7 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG4643-SF Instruction Sheet document without notice. The information herein is believed to D16596-03.doc... -
Page 3: Introduction
It also receives 1 data signal transmitted from the AMG4644-SF. Optical Connection The AMG4643-SF is connected as illustrated below when used with an AMG4644-SF receive unit acting as a point to point system. AMG Systems Ltd. reserves the right to make changes to this... -
Page 4: Connections
RS232 – switch position – low (furthest from BNC connections) DATA CHANNEL B Data Channel B ........Not Present AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG4643-SF Instruction Sheet document without notice. The information herein is believed to D16596-03.doc... -
Page 5: Data And Audio Channel Configuration
RS485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω... -
Page 6: Front Panel Indicators
OUT+ logic one (-V) present on OUT+ This represents the data signals being received on the optical fibre AMG Systems Ltd. reserves the right to make changes to this Page 6 of 8 AMG4643-SF Instruction Sheet document without notice. -
Page 7: Physical Information
Weight ..........750grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position. - Page 8 This page is intentionally blank. AMG Systems Ltd. reserves the right to make changes to this Page 8 of 8 AMG4643-SF Instruction Sheet document without notice. The information herein is believed to D16596-03.doc be accurate. No responsibility is assumed by AMG for its use.
Need help?
Do you have a question about the AMG4643-SF and is the answer not in the manual?
Questions and answers