Sennheiser evolution e 845 Instruction Manual page 6

Using the microphone
Switching the e 845 S on/off
X
Use the on/off switch to switch the the e 845 S on or off.
X If necessary, use the screw
"on" position.
Positioning the microphone
Pos. Resulting sound
C.1 • High proximity effect
(large bass boost)
• Powerful, direct sound
C.2 • Less proximity effect
(less bass boost)
• Some room ambience,
natural, balanced sound
C.3 • Very little proximity effect
(minimal bass boost)
• More room ambience,
indirect sound
If sibilance occurs:
X Position the microphone slightly to the side and not directly in front
of the mouth.
Positioning the monitor loudspeakers
X To prevent feedback and crosstalk, postion your monitor loudspea-
kers in the angle area of the highest cancellation of the microphone
(approx. 120°).
Cleaning and maintaining the e 845
Caution
X
Unscrew the sound inlet basket
X Remove the foam insert from the sound inlet basket
X Use a slightly damp cloth to clean the sound inlet basket
the inside and ouside.
X Reinsert the foam insert into the sound inlet basket
the sound inlet basket on the microphone and screw it tight.
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause
a short-circuit and damage the electronics.
X Keep all liquids away from the product.
X Do not use any solvents or cleansing agents.
to lock the on/off switch
C
Commentary
Very little crosstalk
from other sound
sources
More crosstalk from
other sound sources
Higher crosstalk from
other sound sources
.
in the
B
.
from
and replace
3