Qstarz BT-Q920 Quick Installation Manual

BT-Q920 SiRF Star III Bluetooth GPS Receiver
Thank you for purchasing Qstarz BT-Q920 SiRF Star III Bluetooth GPS Receiver. It is compact and
stylish design with high performance for GPS Navigation.
Main features:
Adopt SiRF Star III GPS chipset
20-Channel GPS Receiver for fast acquisition and reacquisition
The compact GPS receiver with stylish design & soft touching
Super High sensitivity -159dBm
Excellent performance - Cold/Warm/Hot start time: 42/38/1 sec. (average)
Support standard NMEA-0183 at 4800 ~ 38400 bps baud rate
Compatible with Bluetooth Serial Port Profile (SPP) in 10m wirelessly
A. Standard Package
GPS Unit BT-Q920 (1) + Lithium-Ion Rechargeable Battery (2) + Cigarette Adapter (3) + USB Cable (4) + Lanyard (5) + Warranty Card +
Quick Installation Guide. (*Battery is pre-loaded in the GPS unit)
1.
B. Appearance
1. Power jack (mini USB type)
2. Power button
3. Battery status LED (Red)
4. Bluetooth status LED (Blue)
5. GPS status LED (Green)
6. Internal antenna
7. Carrying Strap Hole
C. Battery installation
C-1 Please note the battery is already pre-installed into BT-Q920 GPS unit in advance.
C-2 Take Battery out: Push the rubber pad on the bottom side of the unit (1) and pull out the battery cover (2). Then pull out the battery
connector ,and take out the battery from the unit (3).
1.
C-3 Put Battery in place: Push the rubber pad to right side on the bottom of the unit (1) and pull out the battery cover. Plug-in the battery
connector to the slot of unit (2) and put battery cover on to the cabinet (3), then push back to left side and force it forward to fit firmly (4).
1.
D. Charging your battery
For the first time using the BT-Q920, please charge battery until it is fully charged. Take the USB
cable and connect it to the power jack of GPS unit and recharge through car cigarette adaptor. Or
you can also take USB Cable to charge via PC. This will begin to charge the battery. Charging time
is 4 hours typically.
- When the Power LED is blanking with Red, battery power is low status. Please recharge.
- When the Power LED is On with Red, the battery is under charging mode.
- When the Power LED is Off, the battery is fully charged.
BT-Q920 Quick Installation Guide
2. 3.
7
2.
2.
4. 5.
6
5
1
3.
3.
２
3
4
4.
1