Clas Ohlson FT23-16J Manual page 5

Assembly
1. Align the fan body's foot over
the base and push down until it
clicks into place.
3. Remove the lock nut (3) from the drive shaft, fit the rear safety grille (4) onto the drive
shaft and lock it in place using the lock nut.
4. Fit the fan blade assembly (2) onto the drive shaft (5). Make sure that the metal lock
ring on the inside of the fan blade surrounds the plastic rim and locks the fan blade
assembly securely onto the drive shaft.
5. Align and hold the front grille (1) against
the rear grille so that the screw holes
on both halves are in alignment with
each other. Then fasten the two halves
together by clipping the two clips on the
rear grille over the edge of the front grille.
6. Fasten the two halves of the grille together
by inserting screw through the hole on
the top edge of both grille halves and fasten
them together with the nut.
2. Turn the lock knob on the bottom
of the fan body's foot to lock it to
the base.
5